Konica Minolta KIP C7800 - Manual (Page 76)

KIP Request Operator Guide
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP. © 2011 KIP.
- 72 -
ViewExe=
RemoteControlExe=C:\Program Files\KIP\Unattend\Winuntd.exe
Raster2Tlc=C:\Programs\DS\MTF.Exe
Vector2Tlc=C:\Programs\DS\MH2.Exe
CropExe=C:\Program Files\KIP\Request\crop.exe
TlcMergeExe=C:\Programs\DS\MI.exe
TiffViewer=
AutoRecognize=c:\Programs\DS\MAD.exe
PowerScriptExe=c:\Programs\DS\pscript.exe
QuickViewExe=C:\Program Files\KIP\Request\Qv.Exe
KipPortExe=C:\Program Files\KIP\Request\kawpdft.exe
NestExe=C:\Programs\DS\MPack.Exe
DwfExe=C:\Programs\DS\DwfConvert.Exe
KipConvertExe=C:\Program Files\KIP\Request\KipConve.Exe
ColorConversionExe=
RecallDir=C:\Program Files\KIP\Request\Recall
TempDir=C:\Program Files\KIP\Request\TR
MiniSize=1000,720
Units=ENGLISH
AddHpglCmd=
Values are software switches, used to apply custom commands to HPGL/2 files. This line may contain
one switch, multiple switches, or none. Some switches are specific to certain versions; some are specific
to certain printer models. Switches are case-sensitive. Some switches have a value after the switch,
separated by a space.
AddDWFCmd=
DefaultImage=C:\Program Files\KIP\Request\trol.tlc
DebugVal=0
Used for diagnostic purposes only.
MP=101000
The encrypted master password as set by the installer
ST=00
[MultiplePrinters]
This next section (MultiplePrinters) should not be configured outside of the GUI of Request
[KipPortPrinters]
PrinterName0=~IP1:127.0.0.1~Internal
PrinterName1=~IP1:10.10.1.180~3000
PrinterName2=~IP1:10.10.1.74~7000
PrinterName3=~IP1:192.168.10.34~5000
[ConvertTypes]
Type0=ASCII TXT A
Type1=INI INI A
Type2=OUT OUT A