Konica Minolta MAGICOLOR 2300 - Manual (Page 108)

Status, Error, and Service Messages 100
Service Messages
A service message sometimes occurs as a result of an unusual combination
of events, not because of an actual problem. When the printer stops and a
service message displays in the Status Display message window, turn the
printer off and then back on. This often clears the service message indicator,
and printer operation resumes. Always try this before making a service call.
Service calls should be placed to the vendor from whom you purchased
the printer. If you cannot get service from your vendor, see the Service &
Support Guide for a list of sources of service and support in many areas of
the world. The most current worldwide information can be found at
www.konicaminolta.net/printer/.
This service
message... means... do this...
AIDC Sensor Error AIDC sensor error. Contact Technical
Support with the error
information.
Communication
Error
A communication error
occurred in the parallel
or USB interface. Check that the interface
cable is properly
connected to the printer.
If the error continues to
appear even though the
cables are correctly
connected, contact
Technical Support.
Controller
Internal Error
There is an internal error
on the controller board. Contact Technical
Support with the error
information.
SDRAM Error on
Board
There is an SDRAM
error on the controller
board. Contact Technical
Support with the error
information.