Konica Minolta MAGICOLOR 2300 - Manual (Page 92)

Solving Other Problems 84
Printing
takes too
much time. The printer is set to a
slow printing mode
(for example, thick
stock or
transparency). It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to
power saving mode. It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it (Status
Display’s Print/Maintenance... menu).
The job is very
complex. Wait. No action needed.
Blank pages
come out
during a print
job. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
does not print if the cartridges are
empty.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
printer.
Not all pages
print. The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port. Check your cable.
The Cancel key was
pressed. Make sure no one pressed the Cancel
key while your job was printing.
The media tray is
empty. Check that the media trays are loaded
with media, in place, and secure.
A document is printed
with an overlay file
which has been
created by a
non-magicolor2300W
driver. Print the overlay file using a magicolor
2300W printer driver.
Symptom Cause Solution