Konica Minolta MAGICOLOR 2300 - Manual (Page 26)

Media Types 18
If you have problems feeding 50 sheets, try loading only 1–10 sheets
at a time. Loading a large number of transparencies at a time may
cause static buildup, thus causing feeding problems.
Use transparencies that are
Approved by KONICA MINOLTA
Do not use transparencies that
Have static electricity that will cause them to stick together
What Is the Guaranteed Imageable (Printable) Area?
The printable area on all media sizes is
up to 0.157" (4 mm) from the edges of
the media.
Each media size has a specific
imageable area, the maximum area on
which the printer can print clearly and
without distortion.
This area is subject to both hardware
limits (the physical media size and the
margins required by the printer) and
software constraints (the amount of
memory available for the full-page frame buffer). The guaranteed imageable
(printable) area for all media sizes is the page size minus 0.157" (4 mm) from
all edges of the media.
Nonguaranteed Area—Media Longer Than 11.7" (297 mm)
Any media longer than 11.7" (297 mm) has an additional nonguaranteed area
of 0.236" (6 mm) on the bottom of each page.
Capacity Tray 1 Up to 50 transparencies, depending on their
thickness
Orientation Face up
Type Check http://printer.konicaminolta.net/support (click on
"Answer Base") for currently approved media. To order
approved transparency media, go to www.q-shop.com.
Driver
Media Type Transparency
Duplexing Not supported
a a
a
a
Printable
Area
a = 0.157" (4 mm)