Konica Minolta IC-402 - Manual (Page 2)

2
Using the Fiery X3e System Software Service Kit
T O INSTALL SYSTEM SOFTWARE USING E THERNET
1. Shut down and power off the Fiery X3e (see page 9).
2. Disconnect all cables from the Fiery X3e connector panel.
N OTE : The interface cable attached to the Fiery X3e COPIER port is an Ethernet
cross-over cable. To use this cable in the following step, disconnect this cable from the
print engine.
F IGURE A Disconnecting from the customer’s LAN
3. Connect the Ethernet cross-over cable to the LAN port and to a Windows 2000/XP PC.
F IGURE B Creating an isolated Ethernet network using a cross-over cable
4. Power on the PC and insert the System Software CD into the PC CD-ROM drive.
5. If the file does not start automatically, navigate to the CD-ROM drive and click the icon
for the Installation.exe file.
The Welcome screen appears.
Customer’s LAN
LAN port
COPIER port
N OTE : In this procedure, you can use the COPIER port instead of the
LAN port; however, the COPIER port does not support 1000BaseT.
X
Windows 2000/XP PC
Ethernet cross-over cable
LAN port