Konica Minolta IC-402 - Manual (Page 5)

5
System software
20. If the Select Market Region screen is displayed, select the name of the region for the
Fiery X3e, and then select OK.
This screen is displayed only if English was selected from the language selection screen.
21. At the Setup screen, select Run Setup and press OK. Reenter the customer’s settings
from the Configuration page that you printed earlier.
Enter settings for Server, Network, and Printer Setup, in that order. Ignore the
settings not included on the Configuration page if it is more appropriate for the site
administrator to set them. For more information, see
Configuration and Setup .
22. When all setup options are configured, select Exit Setup from the Setup screen and
press OK.
The Fiery X3e reboots with the updated system software and Setup options.
23. Allow the Fiery X3e to reach Idle.
24. Follow the procedure on page 13 to install the 1-J8PG9.ps and 1-J98TH.ps update files
that are located on the system software update CD.
T O INSTALL SYSTEM SOFTWARE OVER USB
• Except for the following changes, perform the procedure “To install system software
using Ethernet” on page 2:
• At step 3 on page 2, connect a USB cable to the USB 2.0 Type B port instead of
connecting an Ethernet cross-over cable to the LAN port.
F IGURE F Connecting a PC directly to the Fiery X3e via USB
• At step 7 on page 3, select USB connection type instead of Ethernet
• At step 15 on page 4, disconnect the USB cable from the Fiery X3e and the PC
instead of disconnecting an Ethernet cross-over cable.
Windows 2000/XP PC
USB cable
USB 2.0 Type B port
LAN port