Konica Minolta IC-402 User Manual

Page 7

Advertising
background image

7

System software

4.

Verify that the Service Mode switches are in the normal position.

F

IGURE

G

USB flash drive connector and service switches on the Fiery X3e

5.

Attach the prepared USB flash drive to the Fiery X3e (see Figure G).

For convenience, you may attach the USB extension cable (provided) to the Fiery X3e,
and then attach the USB flash drive to the other end of the cable.

N

OTE

:

If dust covers are attached to the USB Type A connectors, remove one dust cover

using needle-nose pliers.

6.

Power on the Fiery X3e using its dedicated AC power switch and wait until installation
is complete.

Installation takes approximately 15-25 minutes. The LED on the flash drive should
indicate that files are being transferred. The Fiery X3e shuts down automatically after
installation is complete.

7.

Remove the USB flash drive from the Fiery X3e.

8.

Reconnect all cables to the Fiery X3e connector panel that are required for normal
operation.

F

IGURE

H

Restoring normal configuration

Service switches are in normal (Open) position

not Service Mode (Closed) position

1 2

1 2

USB Type A connector (1 of 2)

for flash drive or

extension cable

Service switches

Customer’s LAN

X

COPIER port

To print engine

LAN port

Ethernet cross-over cable

Soft power button

Advertising
This manual is related to the following products: