Konica Minolta IC-402 - Manual (Page 9)

9
System software
T O SHUT DOWN THE F IERY X3 E
1. Press the Utility/Counter button on the Control Panel, and then touch the Controller
Details key on the touch panel Utility screen.
Alternatively, touch the icon in the lower-left corner of the main copier screen.
2. Make sure that the Fiery displays Idle.
F IGURE I Fiery X3e LCD info screen
3. Touch MENU to access the Functions screen.
4. Select Shut Down from the Functions screen.
5. Select Shut Down System from the Shut Down screen.
6. Wait until the Utility screen is displayed. Note that the Controller Details key no longer
appears.
The Utility screen may take a few minutes to appear.
7. Power off the Fiery X3e using the dedicated AC power switch.
N OTE : Always use the AC power switch to disconnect the cables between the Fiery X3e
and the print engine or to unplug the Fiery X3e from the AC power outlet. Pressing the
Soft power button powers off the Fiery X3e, but not completely. The Fiery X3e requires
a complete power off before you disconnect the cables.
If you are recycling power, wait at least 5 seconds before powering back on.
8. If you are preparing to remove the Fiery X3e from the print engine, power off the
print engine using its main power switch, and then unplug the print engine.
N OTE : Do not perform this step if you are shutting down the Fiery X3e in order to install
system software.
Unplugging the print engine powers off the Fiery power supply. If the print engine is
plugged in and connected to the Fiery X3e, the Fiery X3e power supply remains on even
when the print engine and the Fiery X3e are powered off. For more information, see the
service documentation that accompanies the print engine.
Fiery X3e
Idle
xxxxMB Vx.x
MENU
Info
Close
Fiery X3e status
(Idle, RIP, etc.)
MENU key
Name of screen (Info,
Functions, etc.)
4 line selection keys
(use to select
corresponding
menu item)
Up and Down arrows
(use to scroll display)
Close key
(use to return to
Utility screen)