Konica Minolta bizhub 282 - Manual (Page 248)

Specifying management settings 7
362/350/282/250/222/200 7-17
Sp
ecif
yin
g
man
age
men
t
set
ti
ngs
Chapter 7
Specifying settings for the image in the results report (Mode 023)
Specify whether or not an image of the transmitted document is added to the
results report
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
Specifying settings for checked receiver transmissions (mode 200)
Specify whether or not the fax transmission is sent after checking the CSI
(called subscriber ID) signal from the recipient’s machine.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected.
Bit 7 6 5 4 3 2 1 0
Setting 1 1 1 1 1 0 0 0 (HEX: F8)
Bit Description Setting Description Page Refer-
ence
7, 6, 5, 4 ----------------------- 1111 *Do not change these bits
when specifying setting
for this function. ----------
3 Specifies whether or
not an image of the
transmitted docu-
ment is added to the
results report. 0 Is not added p. 2-22, p. 3-21,
p. 5-22
1 Is added
2, 1, 0 ----------------------- 000 *Do not change these bits
when specifying setting
for this function. ----------
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 1 0 0 (HEX: 04)
Bit Description Setting Description Page Refer-
ence
7, 6, 5 ----------------------- 000 *Do not change these bits
when specifying settings
for this function. ----------