Konica Minolta NC-503 - Manual (Page 154)

Performing a Scan to Server (FTP) operation 7
NC-503 7-1
7 Performing a Scan to Server (FTP) oper-
ation
This chapter provides descriptions of the procedures for sending scan data
to servers.
7.1 Basic transmission
In order to perform a Scan to Server (FTP) operation, certain settings such as
the FTP server address must be specified in advance. These settings can be
specified using PageScope Web Connection. For details on PageScope
Web Connection, refer to “Using PageScope Web Connection” on page 8-1.
In addition, the FTP server address must be registered as a speed dial
number. Refer to “Registering speed dial destinations (FTP servers)” on
page 5-7.
2
Note
Speed dial settings and settings the destination server address for Scan
to Server (FTP) operations can only be specified from PageScope Web
Connection. These settings cannot be specified from the control panel.
Using the automatic document feeder
1
Press the [Scan] key.