Konica Minolta NC-503 - Manual (Page 32)

Network printing 2
NC-503 2-9
2.3 Specifying an IP address
The following procedure describes how to assign the IP address to the ma-
chine from the control panel.
2
Note
The IP address setting should be specified according to instructions from
the network administrator.
The IP address setting is specified in Utility mode by the administrator.
1
Press the [Utility] key in the control panel.
2
Press the [,] or [+] key until “ADMIN. MANAGEMENT” is selected, and
then press the [OK] key.