Konica Minolta Bizhub 215 - Manual (Page 11)

bizhub 215 2-3
2.2 Connecting to a local area network (LAN) 2
2.2 Connecting to a local area network (LAN)
This machine establishes LAN connection using the TCP/IP protocols. To do this, you need to connect this
machine to a LAN using a network cable.
Tips
- The explanation contained in this manual assumes that the Network Card NC-504 or Image Control-
ler IC-209 is installed on this machine. This machine requires the Network Card NC-504 or Image
Controller IC-209 to connect to a network. Ensure that either of them is installed in this machine.
2.2.1 Connecting a network cable
Insert one connector of a network cable into the network port (LAN) on the left side of the main unit, and insert
the other connector into an available port on the network hub.
Tips
- Use a network cable rated at category 5, 5E, or higher. Note that a network cable is not supplied to-
gether with this machine.
LEDs on the network port
LED1
LED2
LED1 (LINK): This LED lights up when the network cable is correctly connected. If this LED does
not light up even though you have correctly connected the cable, check the connec-
tion. If this LED does not light up even though the both ends of the network cable
are correctly connected, the cable may have been broken.
LED2 (ACT): This LED flashes during data transmission or reception.