Konica Minolta FK-505 - Manual (Page 53)

3 3.3 Basic Faxing
3-14 Fax kit FK-505
Fa
xin
g
Chap
ter
3
3 If necessary, change the “Resolution” setting (p. 3-11).
4 Using the 10-Key Pad, enter the
fax number of the recipient.
❍ The fax number of a previously
programmed recipient can also
be specified. Refer to “Dialing”
on page 3-2.
5 Press the [Start] key.
✎
Note
To specify a scanning area
other than the size of the
loaded document or if the
document size cannot be
detected automatically, press
the [
▼
] key.
In the next screen that
appears, select “MANUAL”,
and then press the [Yes] key.
Then, select the desired paper size, and then press the [Yes] key.
6 Press the [Yes] key.
The document is scanned.
✎
Note
To scan the next document page, press the [Yes] key, and then position the
next document page.
7 Press the [Start] key.
❍ To stop the fax transmission, press the [Stop] key, and then press the [Yes]
key in the next screen that appears.
❍ Once transmission is finished, a beep is sounded.
❍ If the fax could not be sent, the transmission result report is printed (p. 6-50).