Konica Minolta bizhub 181 - Manual (Page 15)

2 Installing the printer driver
2-2 GDI Printer Controller
Connecting to the network
In the following procedure, the machine is connected directly to the compu-
ter by using a network cable.
In order to connect the machine to a network, the optional network interface
card NC-503 or image controller IC-206 must be installed. For details on the
network interface card NC-503, refer to the User’s Guide for the network in-
terface card. For details on the image controller IC-206, refer to the User’s
Guide for the image controller.
When the machine is connected to a network, use the Add Printer Wizard to
install the printer driver. For the procedure on installing the printer driver
when this machine is connected to a network, refer to “Installing the printer
driver by using the Add Printer Wizard” on page 2-13.
Procedures for making connections and installing the driver
The printer driver can be installed by using Plug and Play or by using the Add
Printer Wizard.
The installation procedure differs depending on the method used to make
the connection. Use the installation method that corresponds with the con-
nection method.
2
Reminder
If the machine is to be connected to a USB port, install the driver by using
Plug and Play. If the machine is to be connected to a network, install the
driver by using the Add Printer Wizard.