Konica Minolta bizhub 181 - Manual (Page 85)

4 Control panel operations
4-8 GDI Printer Controller
– Slide the paper
guides to fit the size
of paper being load-
ed.
4
Repeat step 3 as often as necessary until printing of the document is
finished.
2
Note
Be sure to load the paper into the manual bypass tray after the print op-
eration is performed from the computer. Follow the procedure described
below if the paper is loaded into the manual bypass tray before the print
operation is performed from the computer.
Remove the paper from the manual bypass tray.
Press the [Reset] key.
Press the [Printer] key.
Perform step 3 of the procedure.
Load the paper into the manual bypass tray one sheet at a time.
If the multi bypass tray (optional) is installed, printing from it can be per-
formed in the same way as with any other paper drawer since the multi
bypass tray can be loaded with 100 sheets of paper.
The multi bypass tray can be loaded with 10 envelopes, 20 OHP trans-
parencies, 20 postcards, 20 label sheets or 100 sheets of plain paper.
Power Save mode
If print data is received while the machine is in Power Save mode, the mode
is canceled.
When print data is received, the data is printed after the machine has finished
warming up.