AMX UDM-0404 - Manual (Page 25)

Wiring and Connections - UDM Receivers
13 UDM-0404 4x4 Multi-Format Distribution Hub
Wiring and Connections - UDM Receivers
Overview
UDM Receivers include the UDM-RX01 and UDM-RX02. Each Receiver is described in the following
sections.
UDM-RX01
Installed at the display device, the UDM-RX01 (FG-UDM-RX01) converts the signal received from a
UDM Multi-Format Distribution Hub to standard A/V signals (FIG. 10).
With intelligent receiver technology, each UDM-RX01 is powered directly from the UDM Multi-Format
Distribution Hub. As the hub is switched from one video/audio source to another, the receiver detects a
change in signal and automatically switches the output device to its new video format.
UDM Hub Compatibility
The UDM-RX01 is compatible for use with the following UDM Hubs:
UDM-0102 (FG-UDM-0102)
UDM-0404 (FG-UDM-0404)
UDM-1604 (FG-UDM-1604C)
UDM-1604 (FG-UDM-1604)
UDM-RX01 Product Specifications
FIG. 10 UDM-RX01
UDM-RX01 Specifications
Power Requirements: 24VDC @ .75A
Note: The UDM-RX01 is remotely powered by the UDM Multi-Format
Distribution Hub (see Powering on the UDM-RX02 ).
Rear Panel Connectors:
Power Socket: 2.1mm barrel-style DC power socket (female)
UDM Hub (RJ45) Port: Provides audio/video transport as well as control via Cat5, Cat5e or Cat6 to
an UDM Hub.
Serial (RJ12) port: Enables an administrator to control the various functions to the UDM-RX01
from a command line prompt and terminal connection.
• Requires a DB9-to-RJ12 adapter cable (FG-RS01) to connect to a PC.
• 9600, 8 bit, No Parity, 1 Stop Bit
IR Rx Port: 3.5mm stereo input port, for connection of an IR receiver to allow setup of
the UDM-RX01, local compensation controls, and remote control of
centrally located IR devices.