Upgrading input controllers, Backend commands, Changing the login password – AMX UDM-0404 User Manual
Page 84: Checking port details, Multi format inputs
Advanced Administration
72
UDM-0404 4x4 Multi-Format Distribution Hub
Upgrading Input Controllers
1.
Run the TFTP client.
2.
Start a command session on the PC and change to the directory where the .ROM files are stored on
the PC e.g. cd\hub.
3.
Type in the following command at the prompt observing the parameters below;
TFTP –i [IP address] PUT u[filename].[portnumber]
For example typing in TFTP –i 192.168.0.96 PUT ufilename.001 will upload the Input controller
file to Input 1 on the UDM-0404 with IP address 192.168.0.96.
4.
Push Enter to execute the command.
Backend Commands
In case of human error the Command Line can be used to perform several Administrative tasks on the
multi format video hub.
Changing the Login Password
1.
Create a hyperterminal session with the UDM-0404 using default serial connections.
2.
To change the password enter the original password and new password separated by a colon at the
login prompt.
For Example type in admin:endeleo at the login prompt, to change the password from admin to
endeleo.
3.
Reset the Hub. A power off then on is now required.
Obtaining the UDM-0404’s IP Address Via the Command Line
1.
Type i at the command prompt. (FIG. 99) Push enter.
Checking Port Details
Port details (resolution, port firmware) can be checked via the command line also.
Multi Format Inputs
The multi format inputs located at the rear of the Hub are numbered 129 through to 132 for
administrative purposes.
Input Controllers are numbered .001 to .004 and identified by the letter u before the
filename.
FIG. 99
Issuing the i command
Multi format inputs
Input Input Number
A
129
B
130
C
131
D
132