AMX UDM-0404 - Manual (Page 57)

Configuration - Devices Page
45 UDM-0404 4x4 Multi-Format Distribution Hub
Custom Commands
Custom Commands permits the Administrator to specify custom IR commands which can sent to the
device or display. A list of custom commands and their IR value can be found in the Endeleo IR
Codes section on page 77).
To issue a custom command;
1. Select the custom option within the 2
nd
list of commands.
2. Type in the value of the IR code which is to be sent in the relevant box.
3. Execute the custom command or schedule it to occur later.
Issuing Commands to Centrally Located Devices
It is also possible to control centrally located hardware such as DVD players, via options in the Devices
page. Remember an IR-TX bud coming from the rear of the UDM-0404 will sit over the Device’s IR
sensor.
1. Select the device(s) you wish to control by clicking on the appropriate Include checkboxes
(FIG. 49).
2. In the Control toolbar at the bottom of the page, select the command(s) to be performed for the
selected device(s) from the 1st and 2nd (Command) drop-down menus (FIG. 48). Two commands
can be issued to a device (1
st
and 2
nd
).
Alternatively such commands can be scheduled to occur later. Refer to the
Configuration - Schedule Page section on page 47 for details.
FIG. 49 Selected devices
FIG. 50 Optional controls for a device