Compensating video via the udm-rc10 remote control, Elds (fig. 20) – AMX UDM-0404 User Manual
Page 39
Configuration - Status Page
27
UDM-0404 4x4 Multi-Format Distribution Hub
Compensating Video Via the UDM-RC10 Remote Control
Video can also be compensated using the Endeleo UDM-RC10 IR Engineering Remote Control
(FIG. 21).
1.
Ensure the IR03 Endeleo External IR Receiver Module (FG-IR03) is attached to the UDM-RX02 at
the IRRX port (FIG. 21).
2.
To enter compensation mode, push the ESC and B buttons on the remote control.
3.
The amber LED at the Cat5 port on the UDM-RX02 will start to flash, indicating the UDM-RX02 is
in compensation mode.
4.
Use the buttons on the remote control to adjust appropriately the following up or down;
Sharpness
Gain
Red, Green and Blue.
5.
Once the image displayed is of an acceptable quality, push the A button on the remote control to exit
compensation mode.
FIG. 20
Port Configuration options - "Enable advanced options" selected in the
Setup
page and "Advanced" selected
Video compensation settings can also be configured via hyper terminal session. See
the Advanced Administration section on page 67 for details.
FIG. 21
UDM-RX02 with IR03 IR Receiver Module
IR RX port
UDM-RX02
Amber LED blinks to indicate that the RX02 is in Compensation mode
IR03 IR Receiver Module (FG-IR03)