AMX UDM-0404 - Manual (Page 72)

Configuration - Protocols Page
60 UDM-0404 4x4 Multi-Format Distribution Hub
2. Name the serial protocol appropriately and assign the protocol Settings (baud rate and parity).
3. Click on Initialise to clear the UDM Receiver of any pre-loaded serial commands, and invoke the
Action options shown in FIG. 87.
4. Select an Action to be performed from the Action drop-down menu (FIG. 88).
5. Enter the serial command (serial string) equivalent for this action in the Serial command text field.
6. Click Add to create the new protocol.
7. Repeat if necessary for other serial commands which are to be stored under this protocol name.
Once complete, the protocol can be assigned to relevant devices.
When configuring the serial settings "OP" means Odd, Parity and "EP" means Even,
Parity.
FIG. 87 Creating a serial command for the action
FIG. 88 Creating a serial command for the action
Type the serial command string associated
with the selected Action in this text field
Click to add this Action/Serial command
string to the new Serial protocol
The serial string which reflects the action has to be accurate for the serial command
to work. Consult the Manufacturer’s web site or documentation to ascertain the
correct string for this serial device.
It is presumed that the serial device connected to the Endeleo RX has the
appropriate serial settings as described and the correct serial cable/pinouts
configured in order to function correctly with the Receiver.