4 configuring the client software, Configuring the client software, Iq network – Barco iQ Pro G500 User Manual

Page 135

Advertising
background image

14. IQ Network

14.4.4 Configuring the client software

The same universal client interface is used for different network centric projectors (iQ, iD, iCon). The layout of
the interface (position of the controls,...) is adapted after detection of the projector type. Some screenshots
may not fully coincide with the reality.

How to start up the client software ?

1. Start up the previously installed client program

The interface shows 3 tabs (upper tab control ): Control, Diagnosis and Configuration

The active sub interface is the control sub screen (image 14-7)

2. Click on the upper menubar to select the desired sub interface

Image 14-7
Control interface

IP

Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.

How to add a projector to the projector list

1. Click on the white arrow (image 14-8)

A menu is dropped down (image 14-9)

2. click on the + sign of the projector list

A dialog box is displayed (image 14-10)

3. Fill in the Name, the IP address (optional) and the Port number of TCP/IP connection

Note: default port number = 9999

4. Fill in the alias

Tip:

“Alias” is a custom name whereas “Name” is the name by which the projector is identified on the (corporate) network

5. Click OK to confirm or Cancel

The projector is now added to the list of projectors

R5976491 IQ PRO G500 01/02/2007

129

Advertising