If an operation does not work – Olympus D-100 User Manual
Page 90
90
TROUBLESHOOTING
If an Operation Does Not Work
Cause
Remedy
See
When the camera does not work properly
The camera power is off.
Open the lens barrier to turn the camera on.
P. 30
Batteries are inserted the wrong way.
Remove and insert correctly.
P. 29
Cause
Remedy
See
When the flash does not emit light
The subject is too bright.
If you want to use the flash, set the flash mode
to the Fill-in Flash mode.
P. 58
The Continuous Shooting mode is
engaged.
The flash cannot be used in the Continuous
Shooting mode.
Cause
Remedy
See
When the monitor is not clearly visible
The monitor brightness is set
improperly.
Adjust the brightness.
P. 52
You are watching the monitor under
sunlight.
Shade the sunlight with your hand, etc.
The battery power has run out.
Replace the batteries with new ones.
P. 29
Battery performance has dropped
temporarily due to cold.
Warm the batteries by putting them in your
pocket before retrying operation.
P. 29
The camera turned off automatically.
Close the lens barrier and then open it again.
P. 30
The camera is connected to a PC.
Camera operation is not possible while the
camera is connected to a PC.
Dew condensation has occurred
inside the camera.
Let the camera dry without turning it on. Once it
is completely dry, turn it on.
—
—
—
—