Olympus E-100 RS - Manual (Page 60)

60
Turn the power on
2
5 Setting the power switch
OFF : Power off
ON : Power on
RESET :
●
Move the switch to reset momentarily
and then release, the power switch will
automatically move back to ON. Mode
settings in the menu (P.144) will be
reset to the initial settings.
●
Hold the switch in reset position for over
3 seconds, and all settings, except for
the date and time, will be reset to the
initial settings.
1 Push the edge of the lens cap (as
shown by the arrows in the
illustration) to remove the lens
cap.
2 Turn the mode dial to P.
3 Turn the power switch on.
●
The card access lamp blinks.
●
Battery check, as well as the
number of pictures that can still be
stored, will be displayed on the
control panel. (P.60/63)
●
The subject the camera is aimed at
will be displayed on the Viewfinder.
●
To take a picture while viewing the
subject on Monitor, press
(Monitor button). The subject will
be displayed in the Monitor. (P.65)
4 Set the date and time when you
first use the camera. (P.54)
S
M
Prg
A
P
2
1
3
Card access lamp