Olympus E-100 RS - Manual (Page 62)

62
Pre-recording check
2
Checking the batteries
When the power is turned on, the
remaining battery power will be
displayed on the control panel. If it is
low, please replace the batteries. If your
batteries are either NiMH or NiCd,
please charge them when their power is
low.
●
The timing of each battery level indicator varies depending on the type of
batteries used.
●
When the camera is being operated on batteries that are running low, the
camera may emit several short beeps and blink the number of storable
pictures on the control panel after you take a shot or when you turn on the
power. If this happens, the picture you have just taken will not turn out
properly. Replace the batteries and take the picture again.
Note:
Battery check
Control panel
lights and turns off automatically.
The batteries are OK. You are ready to take pictures.
blinks and other indicators on the control panel are displayed
normally.
The battery power is low and the batteries should be replaced. You can
shoot with the remaining power, but the batteries may die soon.
blinks and then turns off after 12 seconds. Other indicators on
the control also go out.
The batteries are dead and should be replaced immediately.