Olympus E-30 - Manual (Page 105)

105
EN
Custom
izi
n
g your cam
er
a
7
AF FOCUS ADJ.
You can use the AF sensor to fine-adjust the focusing position to a range of ±20 steps
(–: closer, +: toward )). Normally, there is no need to change this.
[SET AF DATA]
Fine-adjust the AF default value and register the setting. You can also register the
setting according to the lens.
[OFF]
AF focus adjustment is not performed.
[DEFAULT DATA]
Registers and applies all lens AF adjustment
values not registered individually.
[LENS DATA]
Fine-adjusts the AF for each lens. You register the
adjustment values for up to 20 lenses.
x
Notes
• Depending on the adjustment made, the lens may not focus toward the ) or near side.
• When using a teleconverter, the teleconverter and lens are registered as a set.
• Only Four Thirds lenses can be registered.
[DATA LIST]
This displays the lens information registered with [LENS DATA] from [SET AF DATA].
Select a lens from the list, and then check, delete, or edit the registration information.
To take pictures while slightly changing the AF adjustment value:
j After fine-adjusting the adjustment value, press the shutter button and repeatedly take pictures
before pressing the i button.
Note the following when taking pictures to check the AF adjustment value.
• It is recommended that the record mode be set to a setting higher than YN when taking
pictures.
• Be careful of camera shake, subject movement, and changes in the distance to the subject
when taking pictures.
• It is recommended that you take a picture of a subject with strong contrast within approximately
3 m (9.8 ft.) in the actual shooting environment (lighting and temperature).
• Avoid taking pictures against backlight.
 TIPS
LENS DATA SET
No.1 No.1
14-54 F2.8-3.5
14-54 F2.8-3.5
S/N 000000000
S/N 000000000
EC00
S/N 888888888
±88
+20
±88 W
T
CANCEL SET
Use ac to adjust.
3 12-60 F2.8-4.0
2 14-54 F2.8-3.5
1 14-54 F2.8-3.5
4 12-60 F2.8-4.0
5 50-200 F2.8-3.5
DATA LIST
BACK SET
When the same lens is registered
multiple times, the adjustment
value for the lens with v is
applied.
Select which lens to use when
the same lens is registered
multiple times.
Select this to check, delete, or edit
the selected lens.
E-30_MASTER.fm Seite 105 Mittwoch, 3. Dezember 2008 1:56 13