Barco R9010570 - Manual (Page 47)

7. Advanced
7.3 Source selection
Overview
• Source selection
• Composite video
• S-Video
• RGB-YUV
• PC
• DVI
7.3.1 Source selection
Selecting a source
The Source selection menu allows to select one of the different inputs. Another method to select an input source is via the remote
control using the numeric keys or by using the local keypad.
Selecting a source from the menu bar (OSD) will always display that source in a full screen mode.
When selecting a source with a different resolution (and/or aspect ratio) than the projector’s resolution (and/or
aspect ratio ), the source can be shown in its native resolution or can be re-scaled to the projector’s resolution,
the latter case brings of course some lost of quality.
The resolution of the projector is 1920x1080 with an aspect ratio of 16:9
Selecting a source via the local keypad : the Source button on the local keypad allows to access the Source
selection
menu, continue with the arrow buttons and the ENTER button to select a source via the local Keypad
7.3.2 Composite video
When
Select composite video when you are in presence of a PAL or NTSC video signal.
A composite video signal is often available on a yellow cinch connector of a Camera, VCR or DVD player.
How to select the composite video input ?
1. Press MENU to activate the Tool bar
2. Press ↓ to Pull down the Source Selection menu
3. Use ↑ or ↓ to select L2 Video
Image 7-3
4. Press ENTER to confirm your choice
A bullet indicates the selected composite video source which now appears on the screen.
R59770079 BARCO ID H250/500 23/07/2007 43