Barco R9010570 - Manual (Page 86)

7. Advanced
The Dynacolor™ Interface
Following parameters are available in the Dyancolor™ Interface:
Measured Values These are the colors the projector displays when no color changes are made
Red x, y Coördinates for the Red point
Green x, y Coördinates for the Green point
Blue x, y Coördinates for the Blue point
White x, y Coördinates for the White point
Red L Red Light output
Green L Green Light output
Blue L Blue Light output
White L White Light Output
Desired Values These are the colors you want the projector to display when the status is enabled
Red x, y Coördinates for the Red point
Green x, y Coördinates for the Green point
Blue x, y Coördinates for the Blue point
Cyan x, y Coördinates for the Cyan point
Yellow x, y Coördinates for the Yellow point
Magenta x, y Coördinates for the Magenta point
White x, y Coördinates for the White point
Red g Red Light Gain
Green g Green Light Gain
Blue g Blue Light Gain
Cyan g Cyan Light Gain
Yellow g Yellow Light Gain
Magenta g Magenta Light Gain
White g White Light Gain
Status Enables or disables Dynacolor™
Factory Preset Sets the measured parameters back to the factory preset for the current set
Basic Dynacolor™ Adjustment
We assume we have a basic setup with 2 projectors, the Dynacolor™ adjustment is done by using only the Dynacolor™ menu:
1. Enable Dynacolor™ on both projectors.
2. Assume the first projector has the following measured values.
82 R59770079 BARCO ID H250/500 23/07/2007