Toshiba Magnia 7010 - Manual (Page 67)

Installing Hardware
Adding internal SCSI devices
51
2 Remove the server covers. For more information, see “Removing and
replacing the server panels” on page 19.
3 Remove the device bay bezel and spacer. For more information, see
“Removing a device bay spacer” on page 49.
4 Remove the mounting rails from the spacer.
5 Fasten a mounting rail to each side of the SCSI device and secure the rails
with two screws each.
Installing mounting rails on a SCSI device
NOTE: There are three predrilled holes on each guide rail. Use the square
holes.
6 Remove the FAN module. See “Fan module installation/removal” on
page 37.
7 Remove the device bay's rear cover.
8 Insert the device partially into an empty slot, then connect the power and
signal cables.