Toshiba Magnia 7010 - Manual (Page 84)

Installing Hardware
Installing expansion cards 68
Installing the RAID card
NOTE: If you are going to put the RAID card into the second slot, first
release the memory board. See “Removing a memory module” on page 43
8 Connect the HDD cable to the RAID controller.
Connecting the RAID SCSI cable
9 Replace the server covers.
10 Plug the power cable in, turn on AC power, and start the server.
11 Check RAID controller’s BIOS version and memory in the setup
configuration.
To set up the disk array (RAID) or install the software, refer to the RAID
controller’s manual.
Installing the EMC board
After installing the EMC, the battery pack must charge in the server for three
hours before you can rely on it as a backup power source for the EMC. If the
battery pack is not fully charged before you use it, the batteries will not hold a
full charge.
To install the Emergency Management Card: