Toshiba Tecra S3 - Manual (Page 159)

User’s Manual 8-7
Optional Devices
SD card care
■ Do not write to an SD card if the battery power is low. Low power could
affect writing accuracy.
■ Do not remove an SD card while read/write is in progress.
■ The SD card is designed so that it can be inserted only one way.
Do not try to force the SD card into the SD card slot.
■ Do not leave an SD card partially inserted in the slot. Press the SD card
until you hear it click into place.
■ Do not twist or bend SD cards.
■ Do not expose SD cards to liquids or store in humid areas or lay media
close to containers of liquid.
■ After using an SD card, return it to its case.
■ Do not touch the metal part or expose it to liquids or let it get dirty.
Creation of a boot disk
Within the TOSHIBA SD Memory Boot Utility, a bootable SD memory card
can be created if required. Refer to the Utilities section in Chapter 1,
Introduction , for details.
Memory expansion
You can install additional memory in the computer’s memory module slot to
increase the amount of RAM. This section describes how to install and
remove a memory module.
Set the write-protect switch to the lock position, if you do not want to record
data.
■ Place a mat beneath the computer to prevent scratching or damaging
the computer’s lid when installing/replacing the memory module.
Avoid mats made of materials that generate static electricity.
■ When you install or remove a memory module, ensure that you do not
touch any other internal areas of the computer.