Toshiba Tecra S3 - Manual (Page 81)

User’s Manual 4-13
Operating Basics
Using the USB floppy disk drive (optional)
The optional USB floppy disk drive accommodates 1.44-megabyte or
720-kilobyte floppy disks and connects to the USB port. Refer to Chapter 2,
The Grand Tour , for more information.
Connecting the USB floppy disk drive
To connect the drive, plug the floppy disk drive’s USB connector into one of
the computer’s USB ports.
Connecting the USB floppy disk drive
Disconnecting USB floppy disk drive
When you have finished using the USB floppy disk drive, follow the
procedures below to disconnect it:
1. Wait for the indicator light to go out to make sure all floppy disk activity
has stopped.
2. Click the Safely Remove Hardware icon on the Task Bar.
3. Click USB floppy disk drive device that you want remove.
4. Pull the floppy disk drive’s USB connector out of the computer’s
USB port.
Make sure the connector is back side up and properly aligned with the
socket. Do not try to force the connection, doing so can damage the
connecting pins.
USB connector
USB port
If you connect the USB floppy disk drive after turning on the computer,
it will take about 10 seconds for the computer to recognize the drive.
Do not disconnect and reconnect before 10 seconds has elapsed.
If you disconnect the USB floppy disk drive or turn off the power while the
computer is accessing the drive you may lose data or damage the floppy
disk or the drive.