Toshiba Magnia 3100 - Manual (Page 45)

39 Setup
After Installation (Windows 2000)
After Installation
(Windows 2000)
If you have finished Windows 2000 Server installation, then follow the steps below:
Confirming and Setting up the Time Zone
1.
Start Windows 2000 Server and log onto it as the Administrator (or a user having
equivalent rights).
2. Run Date/Time Properties by clicking Start, Settings, Control panel, and
double clicking on Date/Time.
3. Click Time Zone tab.
4. Check that the current Time Zone setting is correct. If incorrect, select the correct
setting and press [OK].
Setting up the AMI RAID utility (MR466 RAID Controller only)
If the MR466 RAID Controller exists on your server and you want to use the AMI RAID utility
(Power Console, Service, SNMP Agent), you must install it manually after the Windows 2000
Server installation.
To install the AMI RAID utility, follow your MegaRAID User's Manual.
Setting up the Active Directory (To make this server as a domain controller)
If you installed TCP/IP protocol and you want to designate this server as a domain controller in
your network, you must install Active Directory.
For more information about Active Directory, refer to the Windows 2000 Server Help.