Toshiba Qosmio G10 - Manual (Page 134)

User’s Manual 7-4
HW Setup
HDD Priority Options
This option lets you set the priority for HDD detection. If the first detected
HDD has a boot command, the system will boot from the HDD.
■
If only a supervisor password is set, please note the following.
■
The menu above will appear when you use the user password to
start the computer if the ‘Able to run HW Setup’ setting is
configured.
■
The menu above will not appear when you use the user password
to start the computer if the ‘Unable to run HW Setup’ setting is
configured.
■
If the both supervisor and user password are set, please note the
following.
■
The menu above will appear when you use the supervisor and user
password to start the computer if the 'Able to run HW Setup' setting
is configured.
■ The menu above will not appear when you use the user password
to start the computer if the ‘Unable to run HW Setup’ setting is
configured.
■ The menu above appear when you use the supervisor password to
start the computer even if the ‘Unable to run HW Setup’ setting is
configured.
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
Built-in HDD1
−>
Built-in HDD2
(Default)
The computer will look for the Built-in HDD1 first,
followed by the Built-in HDD2 (Default).
Built-in HDD2
−>
Built-in HDD1
The computer will look for the Built-in HDD2 first,
followed by the Built-in HDD1.
■ If a boot command is not found on the first detected HDD, the system
will not boot from the other HDD. It will search the next device in the
boot priority for a boot command.
■ On those models with only a single drive, this item will not be displayed.