Password, Password -6 – Toshiba Qosmio G10 User Manual
Page 186
User’s Manual
10-6
Troubleshooting
Real Time Clock
Password
Unplug the AC adaptor and remove the battery to
make sure the terminals are clean. If necessary
wipe them with a soft dry cloth dipped in alcohol.
Connect the AC adaptor and replace the battery.
Make sure it is securely seated.
Check the Battery indicator. If it does not glow,
let the computer charge the battery for at least 20
minutes. If the Battery indicator glows after 20
minutes, let the battery continue to charge at
least another 20 minutes before turning on the
computer.
If the indicator still does not glow, the battery may
be at the end of its operating life. Replace it.
If you do not think the battery is at the end of its
operating life, see your dealer.
Battery doesn’t power
the computer as long
as expected
Check the power consumption settings in
TOSHIBA Power Saver utility. Consider using a
power saving mode.
Problem
Procedure
The following
message is Displayed
on the LCD:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F1] key to
set Date/Time.
The RTC battery cahrge is getting low or is
exhausted. Set the date and time in BIOS setup
with the following steps:
1. Press the F1 key. The BIOS setup screen will
be displayed.
2. Set the date in System Date.
3. Set the time in System Time.
4. Press End key. Confirmation message will
appear.
5. Press Y key. BIOS setup will terminate and
the computer will be rebooted.
Problem
Procedure
Problem
Procedure
Cannot enter
password
Refer to the
section in
Chapter 6, Power.