Installing/removing batteries, Installing/removing batteries -18 – Toshiba Qosmio G10 User Manual
Page 155
 
User’s Manual
8-18
Using the Remote Controller, AV Buttons and QosmioPlayer
Installing/Removing batteries
Please ensure that you have installed the batteries provided with this 
product before using the Remote Controller.
The procedures for installing and removing the battery vary depending on 
the type of the Remote Controller. Check the type and then install or 
remove the battery as instructed.
Store the battery for the remote control beyond the reach of children.
If a child swallows a battery, this might result in choking. If it happens, 
contact a doctor immediately. 
Observe the following precautions when using the battery of the Remote 
Controller. 
■
Do not use batteries other than those of the type specified.
■
Insert the battery with correct polarity (+ or -).
■
Do not recharge, heat, disassemble or short the battery, or put it into a 
fire.
■
Do not use a battery of which has gone past its recommended expiry 
date (printed on it) or use a battery that is completely discharged. 
■
Do not use different types of batteries or old and new batteries at the 
same time. 
■
Do not carry the battery together with metal necklaces, hairpins or 
other metal accessories. 
■
When storing or dispose of used batteries, make sure to put some 
insulation tape such as cellophane tape on their terminals (+ and -). 
If these precautions are not followed, heating, fluid leakage or explosion 
may occur. This may cause burns or personal injury. If battery fluid gets on 
your skin or clothes, wash immediately with clean water. If battery fluid 
gets in your eyes, rinse your eyes with clean water immediately and see a 
doctor. Do not touch the battery fluid on instruments or devices with bare 
hands. Wipe off with a cloth or paper towel.