Sharp MX-M264N - Manual (Page 666)

7-34
SYSTEM SETTINGS
Contents
*1 When the hard disk drive is installed.
*2 When the automatic document feeder is installed.
*3 When a paper drawer is installed.
*4 When a finisher is installed.
Copy Function Settings
X Disabling of Stapler * 4 Disabled 7-69
N Fusing Control Settings 60 - 89g/m 2 (16 - 23 lbs.) 7-69
N Plasmacluster Settings 7-69
X Plasmacluster Operation at Powering On of Machine ON, Airflow: Low 7-69
X Plasmacluster Operation at Powering Off of Machine ON, Turn off Immediately 7-69
X Status Indicator Setting Pattern 1 7-69
Item Factory default setting Page
P Copy Function Settings
7-70
N Initial Status Settings
7-70
X Colour Mode Full Colour
X Paper Tray Varies depending on the machine
configuration
X Exposure Type Auto
X Copy Ratio 100%
X 2-Sided Copy 1-Side to 1-Side
X Output –
N Other Settings 7-71
X Copy Exposure Adjustment 7-71
X Rotation Copy Setting Enabled 7-71
X Add or Change Extra Preset Ratios – 7-71
X Setting a Maximum Number of Copies 999 7-71
X Initial Margin Shift Setting
7-71 ‹Side 1 10 mm (1/2")
‹Side 2 10 mm (1/2")
X Erase Width Adjustment
7-71 ‹Edge Clearance Width 10 mm (1/2")
‹Centre Clearance Width 10 mm (1/2")
X Card Shot Settings
7-71 ‹Original Size X: 86 mm (3-3/8"), Y: 54 mm (2-1/8")
‹Fit to Page Disabled
X Initial Tab Copy Setting 10 mm (1/2") 7-71
X Disabling Deletion of Job Programs Disabled 7-72
Item Factory default setting Page