Bryant DURAPAC 579F - Manual (Page 34)

— 34 —
XVII. OPTIONAL HINGED ACCESS DOORS
When the optional service package is ordered or the if the
hinged access doors option is ordered, the unit will be
provided with external and internal hinged access doors to
facilitate service.
Four external hinged access doors are provided. All external
doors are provided with 2 large
1 /
4
turn latches with folding
bail-type handles. (Compressor access doors have one latch.)
A single door is provided for filter and drive access. One door
is provided for control box access. The control box access door
is interlocked with the non-fused disconnect which must be
in the OFF position to open the door. Two doors are provided
for access to the compressor compartment.
Two internal access doors are provided inside the filter/drive
access door. The filter access door (on the left) is secured by
2 small
1 /
4
turn latches with folding bail-type handles. This
door must be opened prior to opening the drive access door.
The drive access door is shipped with 2 sheet metal screws
holding the door closed. Upon initial opening of the door,
these screws may be removed and discarded. The door is
then held shut by the filter access door, which closes over it.
SEE
DETAIL
"C"
SEE
DETAIL
"C"
SEE
DETAIL
"C"
579F180 (Low Heat)
579F216-300 (Low Heat) AND 579F180 (High Heat)
579F216-300 (High Heat)
Fig. 45 — Spark Gap Adjustment