Philips AVENT Equipo de extracción doble - Manual (Page 12)

How to assemble your pump
If you are single or double pumping – to assemble the
first pump
(see diagram D)
:
1. With clean hands, insert the white valve (c) into the pump body (d)
from the bottom making sure that the pointed side of the valve faces
downwards.
2. Twist the milk container (e) onto the pump body until securely in place.
3. To ensure the pump doesn’t topple, insert the 125ml/4oz milk container
into the stand provided (f).
4. Place the silicone diaphragm (b) into the pump body (d), making sure it fits
securely around the edge, to create a seal. (This is easier if the diaphragm is
wet.)
5. Carefully insert the Let-down Massage Cushion (g) into the pump body (d),
making sure it completely covers the edge of the funnel. (This is easier if
the Let-down Massage Cushion is wet.)
6. Firmly push the control handle (a) onto the pump body (d) so that it sits
securely on top of the silicone diaphragm (b).
7. If not already attached, push the transparent tube (j) securely onto the
control handle (a) and click the control cable (i) into the adjacent socket.
8. Now attach the other end of the cable into the control cable socket on the
rear of the pump motor (m) and securely connect the twin tubing (k) to the
ports above.
9. You can keep the other transparent tube out of the way for now by
attaching it to the white clip.
10. Connect the electric adaptor (n) to the pump motor (m).
11. Connect the wall plug lead (o) securely to the electric adaptor and then
plug into an electrical wall socket.
12. Switch the pump motor on.
11