Philips AVENT Vigilabebés DECT - Manual (Page 10)

, If no connection is established, the LINK light on the parent unit stops flashing and lights up
red. The parent unit beeps from time to time and the message ‘Not Linked’ appears on the
display. (Fig. 20)
positioning the baby monitor
1 Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 21).
2 Place the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/3 feet away from the baby unit to avoid acoustic feedback (Fig. 10).
For more information on the operating range, see section ‘Operating range’ below.
operating range
The operating range of the baby monitor is 330 metres/1000 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is
up to 50 metres/150 feet.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 30cm/12in 0-10%
Brick, plywood < 30cm/12in 5-35%
Reinforced concrete < 30cm/12in 30-100%
Metal grilles or bars < 1cm /0.4in 90-100%
Metal or aluminium sheets < 1cm/0.4in 100%
For wet and moist materials, the range loss may be up to 100%.
Features
The following features are described in chapter ‘Menu options’, as they can only be operated in the
menu of the parent unit:
- Adjusting microphone sensitivity
- Sound alert on/off
- Setting room temperature range (minimum and maximum temperature)
- Temperature alert on/off
- Vibration alert on/off
adjusting loudspeaker volume
1 Press the volume + or – button on the baby unit until the desired loudspeaker volume for
the baby unit has been reached (Fig. 22).
2 Press the volume + or – button on the parent unit until the desired loudspeaker volume for
the parent unit has been reached (Fig. 23).
, The displays give visual feedback on the volume settings of the units:
- g = parent unit volume switched off/silent baby monitoring
- h = minimum volume (parent unit and baby unit)
- i = maximum volume (parent unit and baby unit)
Note: If the volume is set to a high level, the units consume more power.
talk function
You can use the TALK button on the parent unit to talk to your baby (e.g. to comfort your baby).
EngliSh 10