Philips AVENT Vigilabebés DECT User Manual

Page 19

Advertising
background image

Question

Answer

The microphone sensitivity level of the baby unit may be set too low.

Set the microphone sensitivity level to a higher level in the menu of

the parent unit.
The baby unit and the parent unit may be out of range of each other.

Reduce the distance between the units.

Why does the parent

unit react too quickly to

other sounds?

The baby unit also picks up other sounds than those of your

baby. Move the baby unit closer to the baby (but observe the

minimum distance of 1 metre/3 feet).
The microphone sensitivity level of the baby unit may be set too high.

Decrease the microphone sensitivity level in the menu of the parent

unit.

Why does the parent

unit react slowly to the

baby’s crying?

The microphone sensitivity level of the baby unit may be set too low.

Increase the microphone sensitivity level of in the menu of the parent

unit.

Why do the non-

rechargeable batteries of

the baby unit run low

quickly?

The microphone sensitivity level of the baby unit may be set too high,

which causes the baby unit to transmit more often. Decrease the

microphone sensitivity level in the menu of the parent unit.

The volume on the baby unit may be set too high, which causes the

baby unit to consume a lot of energy. Decrease the volume of the

baby unit.
You may have set a maximum room temperature that is lower than

the actual room temperature or a minimum room temperature that is

higher than the actual room temperature. In this case the display is lit

all the time, which increases the power consumption of the baby unit.

This causes the non-rechargeable batteries of the baby unit to run

low quickly.
Perhaps you have switched on the nightlight. If you want to use the

nightlight, we advise you to run the baby unit on mains power.

Why does the charging

time of the parent unit

exceed 4 hours?

The parent unit may be switched on during charging. Switch off the

parent unit during charging.

The specified operating

range of the baby

monitor is 330

metres/1000 feet. Why

does my baby monitor

manage a much smaller

distance than that?

The specified range is only valid outdoors in open air. Inside your

house, the operating range is limited by the number and type of walls

and/or ceilings in between. Inside the house, the operating range is up

to 50 metres/150 feet.

Why is the

connection lost every

now and then? Why are

there sound

interruptions?

The baby unit and the parent unit are probably close to the outer

limits of the operating range. Try a different location or decrease the

distance between the units. Please note that it takes about 30 seconds

each time before a connection between the units is established.

EngliSh

19

Advertising
This manual is related to the following products: