Philips Vigilabebés DECT - Manual (Page 13)

Talk-back not Speaker volume of Baby Unit is set to 0. Set speaker volume to 1 or higher.
working *
Intercom function Baby Unit is in the baby monitor mode. Set Baby Unit in the intercom mode.
not working * Speaker volume of Baby Unit is set to 0. Set speaker volume to 1 or higher.
Units too far away from each other.
Decrease distance between units.
DECT system check Units too far away from each other. Decrease distance between units.
light (flashing red)/ Batteries are low. Replace/recharge batteries.
System check alarm Units cannot establish a connection, Try solving the problem by using the factory
beeps on Parent Unit even when close to each other. initialisation mode.
*) In talk/intercom function, when either the Parent or Baby Unit is
transmitting, the other unit can only receive and not transmit.
The TALK function of the Parent Unit has priority over that of the Baby
Unit. When both switches are pressed simultaneously, the Parent Unit
TALK function will be activated.
Technical specifications
Power supply: – Battery pack; rechargeable NiMH for Parent
Unit (included)
– Optional batteries 4 x 1.5V; AA for
Baby Unit (not included)
– AC power adapter 230V AC, 50 Hz
Operating range: Up to 300 metres in ideal conditions.
Range will be affected by walls, doors, etc.
Indoors the range may decrease to 50
meters
Operating temperature: 0 °C to 40 °C
Standard: Digital Enhanced Cordless
Telecommunications (DECT)
Only use the AC power adapter included or a type that complies with
safety standard EN60950 and has the following specification:
9 Volt DC/ 200 mA.
ENGLISH 13
XP SBC SC 477.1 Mediaware 13-11-2002 16:08 Pagina 13