Philips Vigilabebés DECT - Manual (Page 8)

Monitoring your baby
Switching on the units
1 Position the Baby Unit at least one metre away from your baby.
Never place the Baby Unit inside the baby ’s bed or playpen.
2 Set the MONITOR/INTERCOM power on switch (8) on the Baby Unit to
MONITOR.
> The DECT system check light (5) blinks (green).
3 Switch on the Parent Unit by pressing the POWER button (18).
> The DECT system check light (14) blinks (green).
> DECT system check lights of Baby Unit and Parent Unit light continuously
(green) when both units have established a connection.
Note: The Parent Unit beeps when it is (accidentally) switched off.
Adjusting loudspeaker volume
Parent Unit
1 Set the Single Point Control mode switch (19) on the Parent Unit to
PARENT VOL.
2 Press the Single Point Control +/- button (20) on the Parent Unit to
increase/decrease the loudspeaker volume of the Parent Unit.
> The sound-level lights (12) on the Parent Unit give visual feedback about
the setting for approximately 3 seconds.
0 lights = monitoring baby silently
5 lights = maximum
Note: A high pitched noise may occur in case the units are too close to each
other. To avoid this you should set the Parent Unit volume to 0 before
placing the units close to each other.
Baby Unit
3 Set the volume/sensitivity selection switch (19) on the Parent Unit to
BABY VOL.
4 Press the Single Point Control +/- button (20) on the Parent Unit to
increase/decrease the loudspeaker volume of the Baby Unit.
> The sound-level lights (12) on the Parent Unit give visual feedback about
the setting for approximately 3 seconds.
0 lights = speaker off
5 lights = maximum
Note:You can only change the Baby Unit volume if the connection between the
Baby Unit and Parent Unit is established.
P A REN
T V
O
L S
EN
SIV
ITY
BA
B
Y V
O
L
P A REN
T V
O
L SEN
SIV
ITY
BA
B
Y V
O
L
LEVEL
SYSTEM
POWER
M O N IT O R IN TE R C O M
O FF
ENGLISH 8
P A R EN
T V
O L SEN
SIV
ITY
B A B Y V
O
L
PA
REN
T V
O
L SEN
SIV
ITY
B A B Y V O L
XP SBC SC 477.1 Mediaware 13-11-2002 16:08 Pagina 8