Philips AVENT Kombinierter Dampfgarer und Mixer - Manual (Page 10)

10 If you want to proceed with blending the steamed food, follow the instructions in section
‘Blending after steaming’ below.
11 Under normal conditions, no water remains behind in the water tank after steaming.
However, in some situations (e.g. in case of scale build-up inside the water tank, interruption
of the steaming process or unintended use), some water could remain behind in the water
tank. In this case, empty the water tank completely after use to avoid bacterial growth. To
descale the water tank, see chapter ‘Cleaning and maintenance’.
Blending after steaming
1 Grab the jar handle and lift the jar off the motor unit. Turn the jar around and shake it so that
the food falls down onto the blade unit (Fig. 14).
Only touch the jar handle. The lid, bottom and outer surface of the jar are hot (Fig. 15).
2 If necessary, remove the lid and add additional ingredients for blending (e.g. water or oil).
Always make sure that the lid has cooled down after steaming before you open it to add more
ingredients (do not exceed the maximum level indication) or to remove the remaining water
from the water tank.
After you have put liquids in the jar, never put the jar in the steaming position.
3 Place the jar upright on the motor unit, i.e. with the lid upwards. Make sure the handle is on
the right-hand side and positioned between the two ridges of the locking area (Fig. 16).
4 Turn the control knob to the blending position. Hold the knob in this position until the food
is properly blended (Fig. 17).
Do not let the appliance blend for more than 30 seconds at a time. If you have not finished
blending after 30 seconds, switch off the appliance and wait a few seconds before you continue. If
the appliance becomes hot, let it cool down for a few minutes before you continue.
Note: If the ingredients stick to the wall of the jar, switch off the appliance and loosen them with the
spatula or add some liquid.
Note: Make sure that the blended baby food has the right consistency (e.g. no lumps) before you serve it.
Note: If the baby food is still too solid add some fluid (e.g. water) until the baby food is soft and smooth.
5 When you have finished blending, simply release the control knob. (Fig. 18)
, The knob automatically returns to the off position.
6 Remove the blended food from the jar. If necessary, use a spatula.
Make sure that the baby food is at a safe temperature for your baby.
7 Unplug the appliance.
8 Under normal conditions, no water remains behind in the water tank after steaming.
However, in some situations (e.g. in case of scale build-up inside the water tank, interruption
of the steaming process or unintended use), some water could remain behind in the water
tank. In this case, empty the water tank completely after use to avoid bacterial growth. To
descale the water tank, see chapter ‘Cleaning and maintenance’.
Blending without steaming
The appliance is intended for:
- pureeing steamed and cooked ingredients for baby food
- blending fluids and fruits for baby drinks
The appliance is not intended for chopping hard ingredients such as ice cubes and sugar cubes.
EngliSh 10