Philips SCF314-02 - Manual (Page 15)

HELPFUL TIP!
The light on top of the twin electronic breast pump Motor indicates the pump mode:
Flashing ORANGE Light: Pump is in warm-up mode. Wait for the continuous GREEN light.
Continuous GREEN Light: Manual pumping mode. You control the speed and pressure
of the pump.
Flashing
GREEN Light: Automatic pumping mode. Your breast pump will mimic your last
established pumping rhythm and level of suction.
Flashing
RED Light: Consult the ‘Troubleshooting Guide’ on page 18.
14 Need Help? Call us at 1.800.54.AVENT or visit www.philips.com/AVENT
7
8
6
5
Your electronic breast pump mimics your pumping: To create a natural
breastfeeding rhythm, we suggest you hold down on the handle for
3 seconds, then release and repeat the pattern for the next compression.
Next, press the blue one-touch memory control on the
handle. The mode light on the pump motor will change from solid
GREEN to flashing GREEN and your breast pump will mimic the
rhythm of the last two compressions.
Note: You do not need to compress the handle fully, only until it feels comfortable. The
further you compress the handle, the more suction the pump will provide. If the pressure
is uncomfortable, stop the automated pumping by pressing the One-Touch Memory
Control and breaking the seal between your breast and pump funnel with your finger.
Changing the speed and level of suction: Press the blue
one-touch memory control on the handle again, and the pump
will revert to manual control. The light will turn from flashing
GREEN to solid GREEN . Establish a comfortable speed and level
of suction. Press the blue one-touch memory control again, and
your Electronic Breast Pump will continue the same pumping rhythm.
Ending pumping session: Press the blue one-touch memory control,
break the seal between your breast and pump funnel with your finger
and remove the pump from your breast. Turn the pump off and
unplug at the power source. Your Electronic Breast Pump will
remember and save the speed and suction level of your last two
compressions. Unscrew the base after milk is collected. If any milk
remains in the pump body, pour it into the base. Do not overfill the
base. Wash and re-sanitize all necessary parts before the next use.
Next time you turn your pump on: Resuming Saved Session? Turn on the pump as in
Step 1. Complete Step 2. Press the blue one-touch memory control.This engages the
automatic pumping mode. The pump will continue with the rhythm of the last two saved
compressions of the milk expression phase. Continue pumping as described in Step 4.
Need to re-establish let-down? If you need to establish let-down, turn on the pump as in
Step 1. Complete Step 2. Squeeze the handle with shallow quick strokes and proceed as
described in Step 3.
CONSULT THE GUIDELINES FOR STORING EXPRESSED BREAST MILK ON PAGE 16 & 17.
Pumping with Your Electronic Breast Pump