Philips SE6581B-17 - Manual (Page 42)

40 Use more of your phone
2
Scroll
n to the number of the unit
you wish to establish the conference
call with and press
o Select.
3
Press
t on the called handset or
l on the base to answer the
internal call, where both internal
callers can talk.
• Intercom is established.
4
Press
c Conf. or long press i
on the first unit to start the three-
party conference.
• Conference will be displayed on
the screen once the conference
call is established.
9.8 Locate Handset
This feature enables you to locate a
missing handset if the handset is in range
and contains charged batteries.
1
Press
a on the base station.
• All the registered handsets start
to ring.
• Once a handset is found, press
c Silent on a handset to stop
its ringing.
2
Press
a again to end the paging.
If there are no key presses within 30
seconds, the handset and base station
will automatically return to idle mode.
9.9 Clock and Alarm settings
This feature allows you to set the date,
time and alarm settings for your phone.
The alarm feature is available only on the
handset.
The procedures in this section refer you
to the Clock & Alarm menu. However
if you access this menu from the base
station, the menu name is “Clock”.
9.9.1 Set Date and Time
1
Press
m in idle mode, scroll n to
Clock & Alarm (Clock on the
base), and press
o Select.
2
Set Date/Time is highlighted.
Press
o Select.
3
The last stored date and time are
displayed. Enter the current time
and current date (HH:MM DD/MM/
YY). Press
u to move the cursor
left, or press
d to move it right.
If using the 12 hour format, just
after setting the minutes, use
*
to switch between AM and PM.
4
Press
o OK.
• A validation tone is emitted and
the screen returns to the idle
mode.
You can change the format as shown in
the next section.
9.9.2 Set Time and Date Format
9.9.2.1 Set Time Format
1
Press
m in idle mode, scroll n to
Clock & Alarm (Clock on the
base), and press
o Select.
2
Scroll
n to Set Format and press
o Select.
Note
Note
Note