OR-Fab 84307 ROCKER PANEL W/ BAR - JK UNLIMITED 4-DOOR - Manual (Page 3)

3 Rocker Panel w/Bar - Kit 84207 & 84307
f. 4 Door Model: Position driver side kit rocker
panel assembly on vehicle. Mark and center
punch two mounting holes on body seam using
rocker panel as templete.
g. Remove kit rocker panel from vehicle.
h. 2 Door Model: Drill marked hole using 3/8” drill.
Enlarge remaining six holes to 3/8”.
i. 4 Door Model: Drill two marked holes using 3/8”
drill. Enlarge 8 holes on body seam to 3/8”
j. 2 Door Model: Install seven kit u-nuts on body
seam.
Kit rocker panel
assembly
Mark
Body
Seam to
Drill
Drill Mark
Location
to 3/8”. Enlarge
Six Holes
to 3/8”.
k. 4 Door Mode: Install ten kit u-nuts on body
seam.
Install
one u-nut Install Six
u-nuts
u-nuts