OR-Fab 84460 XJ CHEROKEE HD ROCK SLIDERS - Manual (Page 4)

JEEP XJ ROCK RAILS 4 Kit # 84460
21. Tighten the frame mounting hardware.
**DO NOT over tighten or strip out can occur**
22. Tighten the spring hanger seam mounting hardware
23. Tighten the rocker seam mounting hardware.
24. Repeat steps 1-23 for remaining Kit Rock Slider.
25. Reinstall any asseccories, fender flares, mud flaps,
etc. that were removed prior to installation of kit
Rock Rails.
After Completing Installation
Engine Compartment
1. Connect both battery cables. Connect positive cable
first, then negative cable.
Miscellaneous
1. Check all fasteners to ensure they are tight.
2. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
WARNING
Retorque all fasteners after 200 miles and after off road
use. All body lift components should be visually
inspected and fasteners retorqued during routine vehi-
cle servicing.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.
Accessories
The following accessories are also available:
Kit# 84450: 4Dr. Side Armor
Kit# 83202: Rock Slider Front Bumper
Kit# 83203: Rock Slider Front Winch Bumper
Kit# 83209: Rock Slider Rear Bumper
Kit Parts List
Qty. Description
1 Rock Rail (Drivers side)
1 Rock Rail (Passenger side)
6 Bolt, Tapping (3/8” x 1”)
4 Bolt, (5/16” x 1”)
4 Nut, Flange (5/16”)
4 Washer, SAE (5/16”)
8 Bolt, (1/4” x 1”)
8 Nut, Flange (1/4”)
8 Washer, SAE (1/4”)
4 End Cap, Urethane