OR-Fab 87017 JEEP THIRD BRAKE LIGHT MOUNT FOR OR-FAB SPARE TIRE CARRIERS - Manual (Page 4)

4 CHMSL - Kit 87017
5. TJ and YJ Wiring
a. Drill a 5/16” hole in the Body in area shown to
route wire with Kit: rubber grommet to original
3rd Brake light wiring.
b. Under Left rear Quarter panel find O.E. 3rd
brake light wire and cut from O.E. connector.
Connect new routed wire with kit: Butt connec-
tors.
6. Cover all remaining exposed wires with Kit: Wire
Loom. Zip tie loom to Tire carrier rack.
7. Install Gecko Cover over LED Light using Kit: #6
Pan Head Phillips Self Tapping bolts.
Parts list
Qty. Description
1 Bracket, Center High Mount Stop Lamp
1 Gecko Cover, Center High Mount Stop Lamp
1 LAMP, LED Light
1 U-Bolt, 1/4” x1 1/2” x 2 3/4”
2 Bolt,#10-24 x 1 1/4”
3 Screw,#6 Pan Head Phillips Self Tapping
2 Washer, 1/4 SAE
2 Nut, # 10-24
2 Nut, 1/4”
4 Grommet, Rubber 5/16” w/ 3/16: bore
4 Butt Connector, 22-18 GA
60” Wire, 20 ga Black
60” Wire, 20 ga white
60” Wire Loom, 1/4” ID
2 Zip tie
Tire
Carrier
Drill 5/16”
hole for
wiring
O.E.
Third
brake
light
Wire.
Insert #6
Self-tap-
ping
Screws
Rev. 01, Copyright 04/08
Performance Automotive Group, Inc.
www.orfab.com