OR-Fab 88003 ROCK DOORS - REAR - JK UNLIMITED User Manual

Before starting installation, Prepare to install rock doors

Advertising
background image

3651 N Highway 89 • Chino Valley, AZ 86323

(928) 636-7080 • www.p-a-g.net

JEEP WRANGLER, RUBICON,
UNLIMITED
REAR ROCK DOOR KIT
INSTALLATION INSTRUCTIONS
2007 - 2012 JK

KIT# 88003

WARNING

Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.

CAUTION

Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.

WARNING

Always wear eye protection when operating power
tools.

WARNING

Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.

JK Rear Rock Door

1

Kit 88003

Before Starting Installation

1. Carefully read all warnings and instructions com-

pletely before beginning.

NOTE

Kit parts are prefaced by the word kit and appear in
bold print.

2. Verify all parts have been received in this kit by

checking the parts list at the end of this document.

3. Only install this kit on the vehicle for which it is

specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.

4. Park vehicle on a clean, dry, flat, level surface and

block tires so vehicle cannot roll in either direction.

Inside Cab

1. Refer to owners manual on how to disable interior

lights when doors are removed.

Prepare to Install Rock Doors

1. Driver side rear door

a. Remove two nuts from two O.E. door hinges.

b. Open door and remove door restraint strap from

pin and vehicle. Removal of access panel on pil-
lar is required to get to strap.

NOTE

If parts are missing from kit, please be prepared to pro-
vide the following information:

1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover

NOTE

The location of the interior door light switch fuse may
vary; check the owner's manual.

O.E. Hinges

Nuts

O.E. Door

Advertising