OR-Fab 88002 ROCK DOOR KIT - JEEP - FRONT JEEP JK WRANGLER / UNLIMITED - Manual (Page 5)

CJ, YJ, TJ, JK Rock Door 5 Kit 88000, 88001, 88002
q. Install kit weatherstrip onto kit door (driver).
Cut kit weatherstrip if necessary for proper fit-
ment.
r. Install kit pad (long) onto upper bar of kit door
(driver).
s. Install kit pad (short) onto lower bar of kit door
(driver).
Kit Door
(Driver)
Kit
Weatherstrip
CJ, YJ Model
TJ Model
Kit
Weatherstrip
Kit Pad
(Long)
Kit Door
(Driver)
Kit Pad
(Short)
t. Install kit pad (cover, driver) onto kit pads.
Adjust as necessary.
u. Repeat above substeps for passenger door.
After Completing Installation
Miscellaneous
1. Check all fasteners to ensure they are tight.
2. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
WARNING
This product is for Off-Road use only. It is NOT
intended as a safety restraint device. Always make
sure all occupants are wearing seat belts at all times.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.
Kit Pad
(Cover,
Driver)
Kit Door
(Driver)